SPECIFICATIONS

Components

Sizes
and weight

Application

The seat is constructed with an internal molded plastic honeycomb frame and covered with marine-grade vinyl. The seat back is attached with heavy-duty aluminum struts and hinges. The seat back folds down for storage.

The Helmseat base is formed from marine-grade King Starboard® solid polyethylene, which is impervious to saltwater and continuous direct sunlight.

Legs are made of polished 1-inch 304 stainless steel tubing, and are removable
for easier storage.

Rail clamps are nylon, with stainless steel hardware. These clamps are designed
for 1-inch diameter stern rails.

All fasteners are stainless steel except the seat hinges and struts, which are aluminum.

No components should degrade with constant exposure to sunlight and salt spray. (An occasional fresh-water rinse helps metal parts.)

A new all-stainless-steel footrest is now available (Mar 5, 2003). A new Captain's Grog Holder is also available (April, 2003).
Catalina 42 seat added (June, 2003). Catalina 28
seat added (June 2004).
Catalina/Morgan 440 added.

Size:

Approximately
33 inches wide,
25 inches high (with
legs installed & seat folded), and
22 inches deep.

Weight: 20 lbs.

Catalina 28

Catalina 310

Catalina 320

Catalina 34

Catalina 350

Catalina 36

Catalina 380

Catalina 387

Catalina 42

Catalina/Morgan 440

Helmseats for other model Catalinas
(30s, and 400s) have been built on a one-off basis -- contact us about your need.

Older model Catalinas with a single backstay attached amidships in the stern (rather than a split backstay) will usually not accept a Helmseat. Models with a "walk-through transom" are the best application for a Helmseat.

We now ship alternate long legs to many customers who prefer to sail without the removable factory fiberglass cockpit seat in the walk-through portion of the stern.

Order a Helmseat	See the Helmseat	Specifications
Guarantee	Contact us	Who we are
Canvas Products	Home Page	Our current Specials